Samsung WEC8500 Operation Manual page 41

Command Automatic Completion Function
The CLI supports the command automatic completion function using the TAB key.
When you press the TAB key after entering the first few characters of a command, the
rest characters of the command that starts with the entered characters is automatically
entered.
If there are several commands that start with the entered characters, press the TAB key
to jump to the next command. The below example shows the 'show', 'save', or 'ssh'
command is entered in order by entering 's' and pressing the TAB key.
WEC8500# s
[When the TAB key is pressed]
WEC8500# show
[When the TAB key is pressed once again]
WEC8500# save
Command Error
When a command that is not supported by the system is entered, an error message is
displayed.
WEC8500# command-unknown
^
Error : Command 'command-unknown'
When a parameter that is not supported by a command is entered, an error message
according to the situation is displayed.
WEC8500# configure test
% Invalid parameter (mandatory)
Command Modes
When the 'exit' command is entered, the mode is changed to the upper command mode.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
does not exist
^
22