Data Network Function; Port Configuration; Port Management - Samsung WEC8500 Operation Manual

Chapter 3
In this chapter, how to set up the data network functions of APC including VLAN, link
aggregation, and layer 3 protocol is described.

Port Configuration

The APC port is configured with a physical interface.

Port Management

Configuration using CLI
To configure the port related function, enter into the interface mode by entering the
'interface [INTERFACE_NAME]' command in the configure mode.
An example of entering into the interface setup mode of the management port is shown
below.
WEC8500# configure terminal
WEC8500/configure# interface mgmt0
WEC8500/configure/interface mgmt0#
The port related CLI commands are as follows:
[auto-nego, speed, duplex]
The commands used to configure an auto-nego, speed, and duplex addresses are shown
below. To delete the configuration, enter the 'no' parameter.
WEC8500/configure/interface ge1# speed-duplex ?
10-full
10-half
100-full
100-half
1000-full
1000-half
auto-nego
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America

Data Network Function

•
Physical interface of 11 ports except WEC8500 console port
•
Physical interface of 4 ports except WEC8050 console port
The WEC8500 Management port is used to manage the WEC8500. It does
not support VLAN and its interface name is 'mgmt0'. The 8 ports at the right
side of Management port are 10/100/1000 BASE T-ports and their names
are
To the right side of the 10/100/1000 BASE T-ports, there are two Gigabit
ports, that is XE1 and XE2. In case of WEC8050, there is no management
(mgmt0) port, connect the Ethernet cable to the port in one of ports ge1 to
ge4.
Set 10Mb/s full-duplex
Set 10Mb/s half-duplex
Set 100Mb/s full-duplex
Set 100Mb/s half-duplex
Set 1000Mb/s full-duplex
Set 1000Mb/s half-duplex
Set auto negotiation speed/duplex
GE1-8.
43