Service Policy Configuration; Time Profile - Samsung WEC8500 Operation Manual

5
6

Service Policy Configuration

Apply the policy configured in the policy-map to an interface.
1
APC# configure terminal
APC/configure# interface ge2
APC/configure/interface ge2#
2
APC/configure/interface ge2# service-policy in p1
APC/configure/interface ge2# no service-policy in p1
3

Time Profile

The procedure of configuring a time profile and applying it to ACL is described.
Time Profile Configuration
Configuration using CLI
1
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
violate-action
aware|color-blind|)
[Peak rate to a class of traffic]
o queue-limit [QUEUE_NUM]
[Peak rate to a class of traffic]
o shape-peak [PEAK_RATE]
Exit the policy-map mode.
o exit
To check the configuration information, use the 'show running-config
network' command.
Go to configure  interface configuring mode to apply the service policy
of CLI.
Apply the policy configured in the policy-map to an interface. The 'no'
parameter is used to delete the policy.
o service-policy [DIRECTION] [POLICY_NAME]
o no service-policy [DIRECTION] [POLICY_NAME]
Parameter
DIRECTION
POLICY_NAME
An example of entering a command is shown below.
To check the configuration information, use the 'show running-config
network' command.
Go to configure of CLI fqm mode.
(drop|(dscp [0-63]|ip
Description
Application direction configuration (in/out)
Policy to apply
[0-7])|transmit) (color-
101