Figure 49. Interface Group Window (1) - Samsung WEC8500 Operation Manual

Interface Group related commands are as follows:
[Creating or Deleting Interface group]
This command creates an interface group. Use 'no' parameter to delete an interface
group.
•
•
[Adding or deleting Interface]
This command adds an interface to an interface group being configured. Use 'no'
parameter to delete an interface.
•
•
•
•
•
•
•
[Retrieving Interface Group Status]
This command retrieves the configuration status of an interface group.
•
This command retrieves the configuration status of secondary IP.
•
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Interfaces Groups> menu in the sub-menus. Click the <Add> or
<Delete> button to add or delete an interface group.
Figure 49. Interface Group Window (1)
Follow the below procedure to add an interface group:
1
2
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
if-group [INTERFACE_GROUP_NAME]
no if-group [INTERFACE_GROUP_NAME]
add-if [VLAN_ID]
no add-if[VALN_ID]
You can use follow commands for the case that add/delete secondary IP
to interface group
add-ip [INTERFACE_IP_ADDRESS]
no add-ip [INTERFACE_ IP_ADDRESS]
add-if[INTERFACE_IP_ADDRESS]
no add-if[INTERFACE_ IP_ADDRESS]
show if-group
show if-group secondary
In the Interface group initial window, click the <Add> button.
Enter information on GROUP NAME and GROUP DESCRIPTION and
50