Samsung WEC8500 Operation Manual page 361

6
7
8
9
10
11
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
function.
o interval [NUMBER]
Parameter
NUMBER
Set the station threshold to perform the Station-based Adaptive Load
Balancing function.
o threshold [NUMBER]
Parameter
NUMBER
Set the time of blocking the reconnection after the load of the station is
now balanced.
o kickout-timeout [NUMBER]
Parameter
NUMBER
To lead the station which performs load balancing to connect to a specific
AP, set the probe response limit time to other APs.
o no-probe-timeout [NUMBER]
Parameter
NUMBER
The rssi-high value is a criterion for excluding candidates for station-
based adaptive load balancing to be selected. The station with the RSSI
value higher than the set value does not attempt at load balancing (In
case of the active mode, N/A).
o rssi-high [NUMBER]
Parameter
NUMBER
The rssi-low value is a criterion for selecting a sticky station. The station
with the RSSI value lower than the set value always attempts at load
balancing.
o rssi-low [NUMBER]
Parameter
NUMBER
The utilization value is a criterion to perform the load balancing. The
Description
Interval for performing load balancing (sec)
Description
Station threshold as the standard for the performance of
load balancing
Description
Reconnection limit time (0~100 sec.)
Description
Probe response limit time (0~100 sec.)
Description
RSSI reference value (-100~0 dbm)
Description
RSSI reference value (-100~0 dbm)
342