Figure 161. Dhcp Server Configuration; Dhcp Configuration - Samsung WEC8500 Operation Manual

DHCP Configuration

The DHCP service of APC consists of DHCP server, DHCP relay, and DHCP proxy.
DHCP Server
DHCP Server Configuration
A DHCP server in the APC dynamically allocates an IP address to a client.
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure #
2
3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<DHCP>  <Internal Server> menu in the sub-menus.
Figure 161. DHCP Server Configuration
Enable/Disable the DHCP SERVER SERVICE item in the Internal Server window to
enable or disable a DHCP server and DHCPIPV6 server.
DHCP Pool
The DHCP pool includes the range of IP address to be allocated to a client, DNS server
that will be used by a DHCP client, NTP server, and default router IP address information,
and so on.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
To enable or disable the DHCP server, enter the 'ip dhcp' command. Use
'no' in front of the command to disable the configuration.
o ip dhcp enable
o no ip dhcp enable
o ipv6 dhcp enable
o no ip dhcp enable
To check configuration information, use the 'show [ip/ipv6] dhcp'
command.
233