Table of Contents
Advertisement
Control Box Installation
Configuring the options of the outdoor unit
for installation of Base heater and control box
When installing Base heater and control box, be sure to enable
the Base heater and control box function for the outdoor unit.
When installing in modules on modular systems (more than one
outdoor unit), enable the function on the main outdoor unit.
Configuring key functions of the outdoor unit
[DVM S Series]
[DVM S2 Series]
Installation and configuration settings at the outdoor unit PCB
Configuring the options>
1
Press and hold K2 to enter the setup. (the system must be
stopped to modify)
•
The following appears. (In case of compressor cut-off
setting, 1 or 2 appears in Segment 4.)
12
English
DB68-12029A-00_IM_ACC BASE HEATER Control KIT_AA_EN.indd 12
•
In Segment 1 and Segment 2, the number of the
selected option appears.
•
In Segment 3 and Segment 4, the setting value of the
selected option appears.
2
In the option setup menu, when you shortly press the K1
switch, the values for Segment 1 and Segment 2 change.
You can select the desired option.
(e.g. The value for Segment 1 is 2 and the value for
Segment 2 is 1.)
3
In the desired option, if you shortly press the K2 switch,
the values for Segment 3 and Segment 4 change. You can
select the desired option.
(e.g. The value for Segment 3 is 0 and the value for
Segment 4 is 1.)
4
After selecting an option, if you press the K2 switch for
2 seconds, all 7-segment displays blink. If you enter the
tracking mode, the option setting is saved.
CAUTION
•
If not normally processed as mentioned above, the option
setting is not saved.
※ Before entry of the mode, if you want to return to the
setting, press and hold the K1 switch to cancel the setting.
※ If you want to reset to the factory defaults, in the
option setting mode, press and hold the K4 switch.
‐
If you press and hold the K4 switch, all the settings
are reset to the factory defaults but the values are
not saved yet. Only when the 7-segment display goes
to the tracking mode by pressing and holding the K2
switch, the setting is saved.
2022-09-06 오전 11:43:24
Advertisement
Table of Contents
