Figure 113.
Remote AP Group's DHCP configure window
Configure Interface of Remote AP Group
If you want to assign multiple VLAN ID to WLAN which belongs to the Remote AP Group
and configured as a Local Bridging, assign Interface and assign Interface group to an
assigned WLAN.
You can add a maximum of 16 VLAN ID for each Remote AP Group, and can create a
maximum of 16 Interface Group. You can also assign a VLAN ID to a created Interface
Group.
Configuration using CLI
To configure Remote AP Group Interface, executes the following command.
1
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group [remote-ap-group-name]
WEC8500/configure/ap-group/[remote-ap-group-name]#remote interface
2
3
4
5
6
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Execute configure Remote AP Group Interface configure mode using
CLI.
Add or delete VLAN
o vlan [VLAN ID]
o no vlan [VLAN ID]
Can check VLAN information using 'show ap-group remote interface vlan
[REMOTE AP GROUP NAME]'command.
Add or delete Interface Group.
o if-group [INTERFACE GROUP NAME]
o no if-group [INTERFACE GROUP NAME]
Can check VLAN information using 'show ap-group remote interface if-
group [REMOTE AP GROUP NAME]'command.
Assign or delete VLAN in the Interface Group.
o add-if [VLAN ID]
o no add-if [VLAN ID]
166