Capwap Configuration; Figure 93. Management Interface Configuration - Samsung WEC8500 Operation Manual

Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <General> menu in the sub-menus.
After entering a configuration in the AP Management of the window, click the <Apply>
button.
Figure 93. Management Interface Configuration

CAPWAP Configuration

A secured tunnel is created between APC and W-EP wireless LAN AP using Control And
Provisioning Wireless Access Point (CAPWAP), that is a standard protocol, and data is
transmitted through the tunnel. An encrypted data is used for both wire and wireless
sections, high security is provided.
The CAPWAP channel consists of control channel and data channel depending on the
type of packet being transmitted/received. The control channel handles provisioning and
configuration/control messages and the data channel transmits the data traffic exchanged
with a wireless terminal through CAPWAP tunnelling. Because the control channel
transmits the wireless LAN configuration information, there should be no data loss.
Therefore, the re-transmission function is basically provided. In addition, the Datagram
Transmission Layer Security (DTLS) is mandatorily used for the security of transmitted
data. Meanwhile, as user data traffic is transmitted through the data channel, a faster
response is preferred instead of packet transmission reliability. Therefore, the re-
transmission function is not provided and the DTLS function is also optional.
For CAPWAP configuration, execute the following commands:
1
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc/capwap#
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc/capwap#
2
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  apc capwap of CLI.
Configure the CAPWAP function using the following commands:
o add-multicast-if [VLAN_ID]: Configure a VLAN ID for multicast
129