Samsung WEC8500 Operation Manual page 47

•
•
•
Setup Step
After setting up the description desired on each screen, click the Apply button to apply
the modifications to the system. The initial setup wizard consists of the following setup
steps:
1
2
3
4
5
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
①: Show the current setup step and the whole setup step by being
located on the top of the screen. When you make the mouse hover over
each number, it shows the name of the step and you can click to move
to the step just before or after the current step.
②: When you press the Next button, you move to the next setup step
and when you press the Prev button, you return to the previous setup
step.
③: Press the Exit button to close the wizard and then move to the
general WEC screen. In the case, you cannot return back to the initial
setup wizard screen. If the APC restarts while the WLAN is not created,
you can go to the wizard screen again.
General setup:
o Set up basic information including the name, location, contact
number, and so on of the system.
o Set up the basic country code and the basic environment.
o Set up the system time and the time zone. Click the PC TIME button
to change the time of the APC by setting to the time of the PC.
Interfaces:
o Create interfaces. For more information, refer to 'Interface
Management' and 'VLAN' part in 'Data Network Function' chapter.
Interface groups:
o Create interface groups and assign the interfaces created at the
previous step.
o For more information, refer to 'Managing Interface Group' part in
'Data Network Function' chapter.
Default Gateway:
o Set up a default gateway of the system. The default gateway is a
default path to be used when the APC communicates with other
equipment on the TCP/IP network.
WLAN:
o Create a WLAN. For more information, refer to '5. WLAN
Management'.
o If the L2 Security Type corresponds to one of the following conditions,
move to the step of setting up a RADIUS server. For more information
on creating a RADIUS server, refer to '8.1.1 External RADIUS
Server':
 (1) 802.1x
 (2) Static WEP + 802.1x
28