Setting Ap Parameters - Samsung WEC8500 Operation Manual

12
13

Setting AP Parameters

Station-based/AirTime-based Adaptive Load Balancing operates as the default value of
the setting of the AP group but it is possible to set other parameter value to an individual
AP. Because it operates in a radio unit, the parameters to change must be set to the
individual radio of the corresponding AP must be set.
Configuration using CLI
To set AP parameters, execute the command as follows:
1
APC# configure terminal
APC/configure# ap ap_1
APC/configure/ap ap_1# load-balancing
APC/configure/ap ap_1/load-balancing#
2
APC/configure/ap ap_1/load-balancing# radio 1
APC/configure/ap ap_1/load-balancing/radio 1#
3
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
channel utilization per station lower than the set value attempts at
airtime-based adaptive load balancing.
o utilization [NUMBER]
Parameter
NUMBER
The interference value is a criterion to perform the load balancing. The
interference higher than the set value attempts at airtime-based adaptive
load balancing.
o interference [NUMBER]
Parameter
NUMBER
Set the interval to attempt at the AirTime-based Load Balancing function.
o airtime-interval [NUMBER]
Parameter
NUMBER
Go to the load-balancing configuration mode in configure  AP of CLI.
Go to the radio to perform the Load Balancing function.
Activate load balancing in the corresponding radio.
o enable
Set the station threshold to perform the Station-based Adaptive Load
Balancing function.
o interval [NUMBER]
Description
Utilization reference value (1~100 %)
Description
Interference reference value (1~100 %)
Description
Interval for performing load balancing (sec)
343