Serial Intreface KIT-K2/ Copy Control Interface
KIT-A1
Points to Note at Installation
• Refer to "Table of Options Combination" when installing this equipment before operation.'
• Serial Interface Kit and Control Interface Kit cannot be used concurrently.
Table of Options Combination
Serial Interface
Kit
yes
yes
Copy Control
Interface Kit
yes
yes
yes: Available
no: Unavailable
CAUTION: Marked portion
When tightening the screws, do not tighten them too tightly. Otherwise, there is a risk
of damage and deformation of screw holes.
9
Installation > Serial Intreface KIT-K2/ Copy Control Interface KIT-A1 > Installation Outline Drawing
yes
-
no
no
yes
no
-
no
F-9-250
9
Installation > Serial Intreface KIT-K2/ Copy Control Interface KIT-A1 > Installation Outline Drawing
Check that the main power switch is OFF
1) Turn OFF the main power switch of the host machine.
2) Be sure that Control Panel Display and Main Power Lamp are both turned OFF, and then
disconnect the power plug.
Installation Outline Drawing
T-9-9
9-102
F-9-251
9-102