Ccd - Canon imageRUNNER ADVANCE C3325 Series Service Manual

■ CCD

COPIER>DISPLAY>CCD
TARGET-B Shading target value (B)
Lv.2 Details To display the shading target value of Blue.
Continuous display of 0 (minimum) or FFFF (maximum) is considered
a failure of the Scanner Unit.
Use case At scanned image failure
Display/adj/set range 0 to FFFF
Appropriate target value 512 - 2047
TARGET-G Shading target value (G)
Lv.2 Details To display the target value of Green.
Continuous display of 0 (minimum) or FFFF (maximum) is considered
a failure of the Scanner Unit.
Use case At scanned image failure
Display/adj/set range 0 to FFFF
Appropriate target value 512 - 2047
TARGET-R Shading target value (R)
Lv.2 Details To display the shading target value of Red.
Continuous display of 0 (minimum) or FFFF (maximum) is considered
a failure of the Scanner Unit.
Use case At scanned image failure
Display/adj/set range 0 to FFFF
Appropriate target value 512 - 2047
GAIN-OB Gain level of Img Sensor odd bit(B)
Lv.2 Details To display the Blue gain level adjustment value in odd-numbered bit
on CMOS Sensor of Scanner Unit.
Continuous display of upper limit is considered a failure of the
Scanner Unit/Main Controller PCB.
When the value is out of the target value range, image failure
or E302 (shading error) may have occurred. Identify the cause
according to the value.
Use case • When replacing the Main Controller PCB
• When replacing the Scanner Unit
• At scanned image failure
Display/adj/set range 0 to 143
Appropriate target value 0 - 143
8
Service Mode > COPIER > DISPLAY > CCD
8 Service Mode > COPIER > DISPLAY > CCD
COPIER>DISPLAY>CCD
GAIN-OG Gain level of Img Sensor odd bit(G)
Lv.2 Details To display the Green gain level adjustment value in odd-numbered
bit on CMOS Sensor of Scanner Unit.
Continuous display of upper limit is considered a failure of the
Scanner Unit/Main Controller PCB.
When the value is out of the target value range, image failure
or E302 (shading error) may have occurred. Identify the cause
according to the value.
Use case • When replacing the Main Controller PCB
• When replacing the Scanner Unit
• At scanned image failure
Display/adj/set range 0 to 143
Appropriate target value 0 - 143
GAIN-OR Gain level of Img Sensor odd bit(R)
Lv.2 Details To display the Red gain level adjustment value in odd-numbered bit
on CMOS Sensor of Scanner Unit.
Continuous display of upper limit is considered a failure of the
Scanner Unit/Main Controller PCB.
When the value is out of the target value range, image failure
or E302 (shading error) may have occurred. Identify the cause
according to the value.
Use case • When replacing the Main Controller PCB
• When replacing the Scanner Unit
• At scanned image failure
Display/adj/set range 0 to 143
Appropriate target value 0 - 143
GAIN-EB Gain level of Img Sensor even bit(B)
Lv.2 Details To display the Blue gain level adjustment value in even-numbered bit
on CMOS Sensor of Scanner Unit.
Continuous display of upper limit is considered a failure of the
Scanner Unit/Main Controller PCB.
When the value is out of the target value range, image failure
or E302 (shading error) may have occurred. Identify the cause
according to the value.
Use case • When replacing the Main Controller PCB
• When replacing the Scanner Unit
• At scanned image failure
Display/adj/set range 0 to 143
Appropriate target value 0 - 143
8-33
8-33