Canon imageRUNNER ADVANCE C3325 Series Service Manual page 759

■ P-STOP
COPIER>TEST>P-STOP
PRINTER Forcible stop of paper feed
Lv.1 Details To forcibly stop paper for the next job at the specified position (only
once).
Leading edge of paper stops at the specified position so that the cause
of a problem can be identified.
Set 99 when checking an image on the ITB.
When the operation is stopped forcibly, jam code "AAxx" is displayed.
When a normal jam occurs at a position other than the specified
position or paper is delivered without being forcibly stopped, this
setting is automatically cleared.
Use case - When bent paper/skew/wrinkles occur
- When jam occurs frequently
- When checking an image on the ITB
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Execute a job (copy/test print).
Paper stops at the specified position.
Caution - Remove the paper being stopped with the normal jam removal
procedure. After jam removal, the job is automatically recovered.
- Display of standard jam code indicates that a jam occurs somewhere
other than the specified position. Setting of forcible stop is enabled
until paper stops at the specified position.
- The setting is disabled for job where paper does not pass through the
specified position.
- Unfixed toner may be adhered on paper depending on the stop
position. Thus, handle it with care.
Display/adj/set range 0 to 255
0: Not forcibly stopped
20: Pre-registration (1st side)
21: Pre-registration (2nd side) *1
30: Pre-fixing (1st side)
31: Pre-fixing (2nd side) *1
32: Post-fixing (1st side)
33: Post-fixing (2nd side) *1
40: Second Delivery (1st side) *2
41: Second Delivery (2nd side) *1, *2
70: Reverse position 1 *1, *4
71: Reverse position 2 *1, *3
72: Duplex standby position *1
99: Pre-fixing (1st side, when checking the image)
Any values other than those mentioned above: Not used
*1: Paper is stopped when a duplex job is executed (paper is stopped
after being reversed)
*2: Paper may not stop depending on the setting of delivery outlet (3
Way Unit-D1 should be installed)
*3: The size of paper should be the one that allows to pass the short
path (e.g.: A4, LTR, etc.)
*4: The size of paper should be the one that allows to pass the long
path (e.g.: A4R, LTRR; 3 Way Unit-D1 should be installed)
Default value 0
8
Service Mode > COPIER > TEST > P-STOP
T-8-65
8 Service Mode > COPIER > TEST > P-STOP
8-208
8-208