Setting Before Turning Off The Power; Check Items When Turning Off The Main Power; Installation Outline Drawing; Installation Procedure - Canon imageRUNNER ADVANCE C3325 Series Service Manual

Setting Before Turning OFF the Power

CAUTION:
Be sure to turn OFF the main power after executing this service mode setting.
Turning OFF the main power without executing service mode causes "E602-5001
(procedure error before installing the HDD Encryption Board)" to occur when turning
ON the main power after installing the Encryption Board. When this error occurs, the
machine needs to be returned again to the initial state in which no Encryption Board is
installed.
1) Execute the following service mode (level 1).
• COPIER > Function > INSTALL > HD-CRYP

Check Items when Turning OFF the Main Power

Check that the main power is OFF.
1) Turn OFF the main power switch.
2) Be sure that display in the Control Panel and the lamp of the main power supply are turned
off, then disconnect the power plug.

Installation Outline Drawing

9
Installation > TYPE-1: HDD Data Encryption Kit Installation Procedure > Installation Procedure > Removing the Covers
■ Removing the Covers
1)
2)
F-9-268
9 Installation > TYPE-1: HDD Data Encryption Kit Installation Procedure > Installation Procedure > Removing the Covers

Installation Procedure

2x
1x
9-114
F-9-269
F-9-270
9-114