User Changes To Factory Default Settings - Symmetricom SSU-2000 User Manual

User Changes to Factory Defaults
User Changes to Factory Defaults
Use Table E-11
Table E-15. User Changes to Factory Default Settings
Setting
Unit Name
Module Information
configurations
User List
configurations
EIA-232-C Port
Comm Port
Timeout
Ethernet IP
Address
Warmup Time
Min Tau Limit
Max Tau Limit
Min Tau
Max Tau
432 SSU-2000 User's Guide
to record any changes you make to the factory default settings.
Factory Default
Communications Module Defaults
SSU_2000
Current Configuration = the configuration that is
currently in use
User Default Configuration = configuration the
user specifies as the default if the current
configuration is invalid or not present
Factory Configuration = the factory default
configuration
Maximum of 25 users including four built-in users
All three comm ports are set to 9600 baud,
Interactive Mode, CRLF, and Echo on
Five minutes for all (Interactive Mode). (Note: the
unit should have one user added, i.e. not in the
INITUSERTABLE state). If it is in the
INITUSERTABLE state, no timeout is applied.
No Timeout is assigned for the TL1 Mode
IP Address 0.0.0.0
Gateway Address 0.0.0.0
Network Mask 255.255.255.0
Clock Module Defaults
1200 seconds
300 seconds
If 2E, 10000 seconds
If 3E, 500 seconds
300 seconds
If 2E, 9000 seconds
If 3E, 450 seconds
User Changes
12713020-002-2 Revision D – April 2004