Symmetricom SSU-2000 User Manual page 293

Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-PRMTR-COMM:[tid]:[aid]:
ctag;
RTRV-PRMTR-ELTIME:[tid]:[aid]:
ctag;
RTRV-PRMTR-FREQ:[tid]:[aid]:
ctag;
12713020-002-2 Revision D – April 2004
Valid aid code: ,
ALL COML
This command returns the current serial protocol settings for
the unit.
When a serial port is specified, the format of the response
message is:
^^^"aid:baud,echo,eol,mode,tout"<cr lf>
where:
= communication port [COML |COMA|COMB]
aid
= communications baud rate
baud
[19200|9600|4800|2400|1200]
= determines if the port operates in full-duplex or
echo
half-duplex [ON|OFF]
= end-of-line character to be used when the unit
eol
transmits ASCII data [CR|LF|CRLF]
= mode of communication [ASCII|TL1]
mode
= inactivity timeout period before the session is
tout
logged out [value |NEVER]
When a Telnet port is specified, some data fields are null,
and the format of the response message is:
^^^"aid:,,,,tout"<cr lf>
Valid aid code:
SxAy
This command returns the time for alarm elevation, from 60
seconds to 500,000 seconds. A setting of 0 (zero) means no
elevation for the alarm. When an alarm has been at MINOR
or MAJOR level continuously for
is elevated to the next level. Delay may be set for each
module or ALL modules, and applies to all alarms created by
the module.
^^^"aid:elevtime" <cr lf>
where: = alarm elevation time for the specified
elevtime
module.
Valid aid code: ,
ALL S1Ay-z
This command returns the MTIE threshold settings for the
DS1/E1 input port designated by the aid.
The format for the response message is:
^^^"aid:freq,fae,fac,fbe,fbc,fatau,fbtay" <cr lf>
where:
= access identifier of the port
aid
= frequency error threshold for A
fae
= clear threshold for A
fac
= error threshold for B
fbe
= clear threshold for C
fbc
fatau = frequency error for A
fbtau = frequency error for B
TL1 Command Interface
Description
, , , , or
COMA COMB TELNET
seconds, then it
elevtime
SSU-2000 User's Guide 293
TL1