Table of Contents
Advertisement
RESTART
Use this command to restart the software for a specified module.
Level 0
Level 1
Level 2
Level 3
Level 4
Remarks
Related
Restrictions This command is based on the target module. It has the SPI
12713020-002-2 Revision D – April 2004
Not applicable
Not applicable
Not applicable
RESTART [xAy]
Use this command to restart the module. If you do not provide a
parameter, the command refers to the Communications Module.
This command requires the whole entry RESTART to be entered to
verify that you want to restart the module. This command requires
a confirmation (YES|NO). If confirmation fails, no action is required.
Same as Level 3 operation
None
None
software RESTART command support. This command assumes
that the target module is working properly. If the target module
does not work, this command has no effect.
Interactive Command Set
SSU-2000 User's Guide 367
Advertisement
Table of Contents
Troubleshooting
