Communications Module Factory Default Settings; Stratum 2E And 3E Clock Module Default Settings - Symmetricom SSU-2000 User Manual

Communications Module Default Settings
Communications Module Default Settings
Table E-1 lists settings and factory defaults for the SSU-2000 Communications
Module.
Table E-1. Communications Module Factory Default Settings
Setting
Unit Name
Module Information
configurations
User List configurations
EIA-232-C Port
Comm Port Timeout
Ethernet IP Address

Stratum 2E and 3E Clock Module Default Settings

The Stratum 2E and 3E Clock module are software configurable via one of the serial
or Ethernet
Table E-2. Stratum 2E and 3E Clock Module Default Settings
Setting
Warmup Time
Min Tau Limit
Max Tau Limit
Min Tau
Max Tau
422 SSU-2000 User's Guide
SSU_2000
Current Configuration = the configuration that is currently in use.
User Default Configuration = configuration the user specifies as the
default if the current configuration is invalid or not present.
Factory Configuration = the factory default configuration
Maximum of 25 users including four built-in users.
All three comm ports are set to 9600 baud, Interactive Mode, CRLF, and
Echo on
Five minutes for all (Interactive Mode). (Note: the unit should have one
user added; that is, not in the INITUSERTABLE state). If it is in the
INITUSERTABLE state, no timeout is applied.
No Timeout is assigned for the TL1 Mode.
IP Address 0.0.0.0
Gateway Address 0.0.0.0
Network Mask 255.255.255.0
ports.Table E-2 lists settings and factory defaults for the Clock module.
Factory Default
1200 s
300 s
2E: 10000 s
3E: 500 s
1000 s
If 2E, 9000 s
If 3E, 450 s
Factory Default
Range
900 to 3600 s
Constant
Constant
In the range specified in Min/Max Tau limits
In the range specified in Min/Max Tau
limits
12713020-002-2 Revision D – April 2004