Symmetricom SSU-2000 User Manual page 321

Level 4
Remarks
Related
Restrictions None
12713020-002-2 Revision D – April 2004
Use this command to set up the expected operation for the
specified alarm number. Only one alarm number can be passed if
you enter additional information.
The additional parameters that you can use are:
Alarm number. See
#
list of alarm numbers
A supervisor can use this parameter to enter the
DELAY
amount of time that an alarm condition must be active
before an actual alarm condition is generated. If an
alarm is specified to be Immediate, no delay time can
be entered. Delay times are in seconds.
Valid delays are 0 to 86,400 seconds (1 day). If the
original value is set to -1 (Immediate) for this command,
delay time cannot be set by the user.
Sets the alarm status level to IGNORE. This means that
IGNORE
no action is taken for an alarm condition.
Sets the alarm status level to REPORT. This means that
REPORT
a report-only message occurs for an alarm condition.
Sets the alarm status level to MINOR.
MINOR
Sets the alarm status level to MAJOR.
MAJOR
Sets the alarm status level to CRITICAL.
CRITICAL
Same as Level 3 operation.
Use of this command implies that the operator is querying the state
of the unit. All information is presented as concisely and completely
as possible. Each alarm is listed on a separate line.
ELEVTIME, STATUS
Interactive Command Set
Alarm Messages, on page 242 for a
SSU-2000 User's Guide 321