Input Module Event Messages - Symmetricom SSU-2000 User Manual

Table A-7. Communications Module Event Messages (Continued)
Event Message
SNMP Trap, ALM, COML\
Chg KeepAlive, ALL, 15 minute, COML\
Err Delay, (1), 300 sec, COML\
Alm Level, (2), Rep, COML\
Elevate Time, 3600 sec, COML\
Setup, Save, COML\
Table A-8. Input Module Event Messages
Event Message
Install, Input Module\
Remove, Input Module\
Enable, Input Module, COML\
Disable, Input Module, COML\
Restart, in 5 seconds, COML\
Cannot Enable, Input Module, COML\
Zero Phase, B, COML\
Rcv Pql Chg, 3\
Pha Buildout, 334000, 335000\
DS1 Framer, ESF, COML\
E1 Framer, CCS, COML\
Freq, 10 MHz, COML\
ZS, On, COML\
SSM, Off, COML\
CRC, On, COMl\
12713020-002-2 Revision D – April 2004
Event #
206 The SNMP Trap Port has been set to send
traps on alarms only by the user
207 The Keep Alive timer has been set to the
interval shown
251 An alarm delay time change
252 An alarm level change
253 An alarm elevation time change
254 User defaults change or save
Event #
DS1/E1 Input Module Events
129 Module Installation
130 Module Removal
131 The Input module has been enabled
132 The Input module has been disabled
133 Module re-boot
134 Internal firmware conflict. Restart module, if
the problem persists, call Symmetricom
Global Services
144 User has forced the phase to be cleared
145 Input has received a different PQL
146 Input performed phase buildout and
difference in Phase that cause PBO
193 An Input framer setup change
194 An Input framer setup change
195 User changed input framer setup
196 User changed input framer setup
197 User changed input SSM capability
198 User changed input framer setup
Event Messages
Event Description
Event Description
SSU-2000 User's Guide 257