Communications Module Event Messages - Symmetricom SSU-2000 User Manual

Table A-6. Clock Module Event Messages (Continued)
Event Message
Err Delay, (1), 300 sec, COML\
Alm Level, (2), Maj, COML\
Elevate Time, 7200 sec, COML\
Setup, User Default, COML\
Table A-7. Communications Module Event Messages
Event Message
KeepAlive, SSU2000
Install, Comms Module\
Remove, Comms Module\
Enable, Comms Module, COML\
Disable, Comms Module, COML\
Restart, in 5 seconds, COML\
Log In, JAY, COML, level: 2\
Log Out, JOHN, COML, level: 2\
Auto Out, SMITH, COML, level: 3:\
Msg, <HELLO USER>, COML\
Not Acknowledged, 1A01\
Module Status, Bad, 1A04\
UTC TIME, Valid/Invalid
TODSYNC, TIMEOUT
Upgrade Image, Start/Complete
Upgrade, 1A01
12713020-002-2 Revision D – April 2004
Event #
251 The user has changed Alarm Delay time
252 The user has changed Alarm level
(IGNORE, REPORT, MINOR, MAJOR,
CRITICAL)
253 The user has changed alarm elevation time
change
254 The user has set the module's configuration
Event #
105 The Keep Alive function has been enabled/
disabled
129 Module installation
130 Module removal
131 The Comms module has been enabled
132 The Comms module has been disabled
133 Module reboot (Warm boot)
144 User at indicated level has logged in on
indicated port
145 User at indicated level has logged out from
indicated port
146 System automatically logging out a user
147 Message sent from a user
148 Module configuration could not be obtained
150 Module did not boot properly
151 Time of startup, when NTP is enabled but
GPS time is not being used
152 Time of day (TOD) was requested by the
Comms module, no response from the GPS
module
153 System firmware upgrade was started or
completed
154 Module's firmware upgrade has started
Event Messages
Event Description
Event Description
SSU-2000 User's Guide 255