Table of Contents
Advertisement
TL1 Command Interface
Table B-6. TL1 Set Commands (Continued)
Command
SET-PRMTR-NTP:[tid]::ctag::
mode,ip,interval;
SET-PRMTR-OUTE12048:[tid]:
[aid]:ctag::[pstate],
[bypass],[zs],[signal],
[squelch];
310 SSU-2000 User's Guide
Valid aid code: none
This command sets the NTP client and NTP broadcast mode
of operation.
can be set to [client|bclient|broadcast|del|clrall]
Mode
mode will request the time from the time server (as
Client
defined by the ip, internet protocol address), this time will be
used to set the time in the SSU.
mode accepts time from a broadcast server that is
Bclient
specified by the ip parameter.
mode configures the SSU as a broadcast time
Broadcast
server at the specified ip, the broadcast
seconds) defines the rate at which the time will be broadcast
by the server.
The
mode deletes the specified ip from the list of peers;
del
up to 3 ip's can be assigned for all peer modes combined.
deletes all peer addresses. If 3 ip's have been defined
Clrall
and a 4th ip is defined, the system returns a DENY message;
you must delete one of the 3 ip's prior to adding the new ip.
Valid aid code:
,
ALL
SxA[y[-z]]
This command sets the output parameters for the
E1/2048 kHz Output module.
where:
= [ON|OFF] to enable or disable the port
pstate
= [ON|OFF] for allowing Clock C selection
bypass
for framed outputs = [ON|OFF
zs
= [E1|2048]
signal
= [0|1|2|...|16] turn on/off the output if a reference
squelch
clock PQL value exceeds the squelch value. 0 disables
the squelch function.
Empty fields leave parameters unchanged.
Description
interval
12713020-002-2 Revision D – April 2004
(in
Advertisement
Table of Contents
Troubleshooting
