Symmetricom SSU-2000 User Manual page 295

Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-PRMTR-KEEPALIVE:[tid]::
ctag;
RTRV-PRMTR-LRM:[tid]:[aid]:
ctag;
RTRV-PRMTR-LRMCID:[tid]:[aid]:
ctag;
12713020-002-2 Revision D – April 2004
Valid aid code: None
The Keep-alive function causes autonomous messages to
be transmitted at a user selectable interval. This command
returns the current TL1 and SNMP keep alive settings for the
unit. The format of the response message is:
^^^"tl1_time,snmp_time"<cr lf>
where:
= TL1 session timer in minutes
tl1_time
= SNMP session timer in minutes.
snmp_time
Times set to zero indicate keep-alive is disabled
Valid aid code: ,
ALL SxA[y[-z]]
This command returns the LRM port setting. The format of
each port response line is:
^^^"aid:enable,lbo,slip,flt" <cr lf>
where:
of the port,
aid
= {ON|OFF} to enable or disable a port
enable
= Line Build-Out length setting of {133|266|399|533|
lbo
655} feet for DS1 outputs
= slip error threshold in any 24 hour period
slip
= {AIS|SQUELCH}. It defines side 1 output
flt
generation when the LRU has a loss of signal on side 1
input, loss of all reference sources (PLL unlock), or if the
input signal's frequency has exceeded the LRU's ability
to retime data.
Fault CTA Installed
Side 1 LOS FLT STRATEGY
PLL Unlock CTA Engaged
Excessive Input FLT STRATEGY
Frequency
Valid aid code:
ALL, SxA[y[-z]]
This command returns the LRM port circuit id. The format of
each port response line is:
^^^"aid:cid" <cr lf>
The line contains the aid of the port, cid is a string from 0-43
characters circuit id
TL1 Command Interface
Description
CTA Not Installed
FLT STRATEGY
FLT STRATEGY
FLT STRATEGY
SSU-2000 User's Guide 295