Symmetricom SSU-2000 User Manual page 370

Interactive Command Set
SNMP
Use this command to provide access to SNMP user list and provide the SNMP
manager IP addresses.
Level 0:
Level 1:
Level 2:
Level 3:
Level 4:
370 SSU-2000 User's Guide
NA
SNMP [USER|MANAGER]
If this command is used with any operand, it will display the valid
SNMP user names and their associated access levels. It also
displays the SNMP enabled/disabled mode, and SNMP manager
IP addresses.
Options are:
Displays the valid SNMP user names and their
USER
associated access levels
Displays the SNMP manager table contents
MANAGER
Same as level 1 operation
Same as level 2 operation, with the following additions:
SNMP [DISABLE|ENABLE]
SNMP TRAP {ALARM|ALL}
Options are:
Disables the SNMP agent
DISABLE
Enables the SNMP agent and allow MIB manager to
ENABLE
see the view
Allows user set filter for SNMP trap (event port)
TRAP
Only Alarm Traps sent out
ALARM
All Traps sent out
ALL
Same as level 3 operation, with the following additions:
SNMP USER [{INIT|ADD|MODIFY|DELETE}]
SNMP MANAGER [INIT|{ADD|DELETE}]
Options are:
SNMP User Table
USER
Clears the whole SNMP user table and only leaves the
INIT
built-in users in the systems. This option clears the
table.
[ip_address]
12713020-002-2 Revision D – April 2004