Symmetricom SSU-2000 User Manual page 355

NTP
Use this command to provide access to the NTP in the SSU-2000. NTP can run as
a server application, a client application, and in broadcast mode. The server always
runs and the client and broadcast modes are enabled independently by assigning
an address and setting a timer.
Level 0:
Level 1:
Level 2:
Level 3:
Level 4:
Remarks:
Related:
Restrictions: The maximum number of peers is three. Users can assign a newly
12713020-002-2 Revision D – April 2004
NA
NTP
Displays the NTP data: root delay, root dispersion, peer delay, peer
dispersion, and peer offset.
Same as level 1 operation.
NTP ADDPEER {CLIENT|BROADCAST|BCLIENT} ip_dotted_address
NTP DELPEER ip_dotted_address
NTP CLRALL
NTP BTIMER {32|64|128|256|512|1024}
Options are:
Add NTP peers (servers) to enable broadcast or client
ADDPEER
mode
The IP for NTP server in client mode
CLIENT
The subnet mask for broadcasting mode
BROADCAST
The IP for NTP server in broadcast client mode
BCLIENT
Removes NTP servers from the peer table
DELPEER
Clear all the NTP peer addresses in the unit
CLRALL
Set the broadcast timer for 32/64/128/256/512/1024
BTIMER
seconds interval
Same as level 3 operation
None
None
created peer to client or broadcast. Normally two peers are used
for clients and one peer is for broadcasting (depending upon user
requirements).
Interactive Command Set
SSU-2000 User's Guide 355