Table of Contents
Advertisement
Interactive Command Set
NAME
Use this command to view and set the unit name.
Level 0
Level 1
Level 2
Level 3
Level 4
Remarks
Related
Restrictions None
354 SSU-2000 User's Guide
Not applicable
NAME
Use this command to display the unit name.
Same as Level 1 operation
NAME unit_name
Sets the current unit name. You can use up to 20 characters for the
unit name. This name is for identification purposes only.
Same as Level 3 operation
The name displays as part of the prompt
Valid names must start with a letter. If TL1 is to be used, care must
be taken in the assignment of the unit name as it is the Target
Identification (TID) for that mode.
12713020-002-2 Revision D – April 2004
Advertisement
Table of Contents
Troubleshooting
