Symmetricom SSU-2000 User Manual page 374

Interactive Command Set
TDEV
Use this command to view TDEV information from the selected input port.
Level 0
Level 1
Note: If you specify times and dates, TDEV displays that occurred
after the starting date and time and before the ending date and time.
Specified dates have the format yyyy-mm-dd, and specified times
have the format hh:mm:ss.
Specified dates and times are not provided in ISO timestamp format,
and are separated by a space. Start time and stop time both default to
the current time of day. Stop date defaults to the current date. Start
date defaults to the current date, minus 24 hours.
Level 2
Level 3
Level 4
Remarks
Related
374 SSU-2000 User's Guide
Not applicable
TDEV xAy-z [{A| B}] startdate [starttime] [stopdate
[stoptime]]
TDEV xAy-z [{A| B}] starttime [stopdate] [stoptime]
Use this command to display the TDEV information calculated on
the input modules. A|B specifies Clock A or Clock B. The default is
the selected clock output.
To perform a TDEV calculation, start and a stop time are required.
If none are specified in the command line, the time defaults to the
last 24 hours. If the stop time is not specified, the current time is
assumed.
This command displays the returned TDEV values and the window
sizes for which they are valid. The command also displays the start
and stop time for TDEV calculation.
TDEV xAy-z [{A|B}] HISTORY [count]
A|B specifies Clock A or Clock B. The default is the selected clock
output. This command displays the one-day TDEV history for the
last one to 100 days.
Same as Level 1 operation
Same as Level 2 operation
Same as Level 3 operation
Since TDEV is an intensive calculation, you can only specify one
port.
None
12713020-002-2 Revision D – April 2004