Table of Contents
Advertisement
TL1 Command Interface
Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-DATA-GPS-AVAIL:[tid]:
[aid]:ctag;
RTRV-DATA-FREQ:[tid]:[aid]:
ctag;
RTRV-DATA-INPUT:[tid]:[aid]:
ctag;
278 SSU-2000 User's Guide
Valid aid code:
or
S1A3
This command returns the current tracking data for the
specified GPS input. If the input specified is not a GPS
module, a DENY response is returned.
The format for the valid response message is as many as 12
lines in the format:
^^^"aid:prn,health,azimuth,elevation"<cr lf>
where:
Each line displays information for one of the satellites
currently being tracked;
= satellite vehicle number
prn
= current health of the satellite: H (healthy) or U
health
(unhealthy)
and
azimuth
elevation
satellite
Valid aid code: ALL,
S1Ay[-z]
This command returns the current frequency measurements
for the specified input(s).
The format of the response message is:
^^^"aid:freqa,freqb"<cr lf>
where:
= frequency of the port versus clock A
freqa
= frequency of the port versus clock B
freqb
Valid aid code:
,
ALL
S1Ay[-z
This command returns the current LOS, AIS, OOF, BPV,
CRC Error and Clear counts for the specified inputs.
The format of the response message is:
^^^"aid:loserr,losclr,aiserr,aisclr,ooferr,
oofclr,bpverr,bpvclr,crcerr,crcclr"<cr lf>
where:
and
???err
???clr
cleared second counts for each of the signal faults as
listed above.
Description
(for a GPS module)
S1A5
= calculated orientation of the
]
are the erred second count and
12713020-002-2 Revision D – April 2004
Advertisement
Table of Contents
Troubleshooting
