Symmetricom SSU-2000 User Manual page 313

Table B-6. TL1 Set Commands (Continued)
Command
SET-PRMTR-SNMPV3-USER:[tid]
::ctag::mode,[username],
[authAlgorithm],[auth],
[priv],[level];
SET-PRMTR-TL1FORMAT:
[tid]::ctag::mode;
SET-USER:[tid]::ctag::
mode,[username],
[password],[userlevel];
12713020-002-2 Revision D – April 2004
Valid aid code:
none
This command allows changes to the SNMPv3 security
system.
= {ADD|DEL|MOD|INIT}
mode
where:
= user identification (up to 20 characters)
username
= authentication {MD5|SHA} algorithm
authAlgorithm
(HMAC-MD5 or HMAC-SHA)
= authentication key with 16 characters if MD5 and
auth
20 character if SHA
= privacy key with 16 characters
priv
= user access level 1 through 3
level
The requirements of each field depends upon the first
parameter "mode" you are choosing
ADD requires entering all fields
DEL only requires a username to delete the user from the
table
MOD requires a username and all necessary fields you
want to modify. The AuthAlgorithm field is ignored. Users
cannot modify the authentication algorithm. To change the
authentication algorithm, delete the user first and then add
the user again using a different authentication algorithm.
INIT requires no additional parameters and clears all
entries in the table.
Valid aid code: none
This command sets the format of autonomous messages.
mode = {GR831|GR833}
where:
GR831 = format specified by GR831
GR833 = format specified by GR833.
See Autonomous Report
information.
Valid aid code: none
This command allows changes to the user list.
= {ADD|DEL|INIT}
mode
where:
requires a
ADD username
only requires a username to delete the user from the
DEL
table
requires no additional parameters and clears all
INIT
entries in the table except for the default Guest and Admin
entries
(1 through 4), defaults to 1 if not entered
userlevel
TL1 Command Interface
Description
Conventions, on page 272, for more
and
password
SSU-2000 User's Guide 313