Lrm Event Messages - Symmetricom SSU-2000 User Manual

Event Messages
Table A-8. Input Module Event Messages (Continued)
Event Message
Restart, in 5 seconds, COML\
Cannot Enable, CC Input Module,
COML\
Zero Phase, B, COML\
Out of Window, Positive BPV
Sync Clock C, Start
Subtending On
Port, Dis, COML\
Priority 5, COML\
Prov PQL, 4, COML\
Err Cnt, BPV, 16, COML\
Clr Cnt, BPV, 5, COML\
IoName, Chg
Err Delay, (0), 10 sec, COML\
Alm Level, (2), Maj, COML\
Elevate Time, 86400 sec, COML\
Setup, Save, COML\
Table A-9. LRM Event Messages
Event Message
Install, LRM Module
Remove, LRM Module
Enable, LRM Module, COML
Disable, LRM Module, COML
Restart, in 5 seconds, COML
CTA, Not Installed
Signal Path
Port Cntl, Port[2-3], Disable, COML
260 SSU-2000 User's Guide
Event #
133 Module re-boot
134 Module cannot be enabled due to
configuration error
144 User has forced the phase to be cleared
146 Positive BPV reversed
147 Start syncing clock C to selected clock
148 Subtending mode is enabled
199 User has disabled the input
201 User has changed the Priority setting
203 User has changed the PQL to the setting
shown
207 User has changed the BPV error threshold
208 User has changed the BPV clear threshold
224 User has changed the port name
251 User has changed the alarm delay time
252 User has changed the alarm level
253 User has changed the alarm elevation time
254 User defaults have been set and saved
Event #
129 Module Installed
130 Module Removed
131 Module Enabled
132 Module Disabled
133 User request for a module to reboot
145 Assembly not installed
146 Signal is through re-timer module or
cut-through
193 Port control on ports 2 and 3 disabled
Event Description
Event Description
12713020-002-2 Revision D – April 2004