Symmetricom SSU-2000 User Manual page 285

Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-EVENT:[tid]:[aid]:ctag::
[count],[start],[stop];
12713020-002-2 Revision D – April 2004
Valid aid code: ,
ALL SxAy
This command returns stored event data.
(or aid range) is optional and may be used to limit the
aid
report to specified modules. With an aid of ALL or null, all
event data between start and stop time is returned.
specifies the number of previous events to display
count
[1 to 500]
and = an optional time interval for events to
start stop
be retrieved. The start and stop times are specified in the
format MM-DD,HH-MM (month. day. time in hours and
minutes). One line containing the time stamp and event
message is returned for each event in the log.
The format for event log report is:
^^^"aid:ntfcncde,condtype,srveff,ocrdat,ocrtm:
condscr" <cr lf>
where:
= Notification Code (CR, MJ, MN, CL, NA)
ntfcncde
= Condition Type (event number)
condtype
= service affecting flag: SA = service affecting,
srveff
NSA = non-service affecting
= occurrence date
ocrdat
= occurrence time
ocrtm
= condition description string
condstr
= start time specifies the start date and time for
start
data in the format MM-DD,HH-MM. If the date is null but
followed by a time, the command defaults to the current
date. If the start time is null, but preceded by a date, the
command defaults to the current time. If the start date
and time are null, the command defaults to the start of the
data. The comma must be present to indicate a null start
time.
= stop time specifies the stop date and time for data
stop
in the format MM-DD,HH-MM. If the date is null but
followed by a time, the command defaults to the current
date. If the stop time is null but preceded by a date, the
command defaults to the current time. If the stop date
and time is null, the command defaults to the end of the
data.
TL1 Command Interface
Description
SSU-2000 User's Guide 285