Denied Response Error Codes - Symmetricom SSU-2000 User Manual

TL1 Command Interface
where:
(Source Identifier) is the returned ID, and is the same as the tid in the input
sid
command message
is the current year, month, and day in the SSU-2000 in the format:
date
YY-MM-DD.
is the current hours, minutes, and seconds timestamp information in the
time
SSU-2000 in the 24-hour format: HH-MM-SS
(Correlation Tag) field is a six-digit alpha-numeric message identifier code
ctag
that is received with the command and returned in the response, for correlation of
message and response within the operating system
is the deny message
DENY
(Error Code) is a four-character error code that explains the reason for the
ercd
deny, and is one of the following defined codes (other error codes may be
defined and used, if required).
Table B-3. Denied Response Error Codes
Error Code
ICNV
IIAC
IICT
IITA
IPEX
IPMS
IPNV
SDNR
Autonomous Report Conventions
The SSU-2000 sends autonomous reports in response to a detected alarm
condition or status change. You can select one of two formats for autonomous
messages: GR-831 or GR-833. Use the RTRV-PRMTR-TL1FORMAT command to
select which format is generated. These reports are similar to the RTRV-ALARM
command responses, but contain an alarm code rather than the complied line.
The GR-831 format for an autonomous alarm report is:
<cr lf lf>
^^^sid^date^time <cr lf>
alrmcde^atag^REPT^ALM^[AIDTYPE]<cr lf>
^^^"aid:ntfcncde,condtype,srveff,ocrdat,ocrtm:condscr"<cr lf>
272 SSU-2000 User's Guide
Definition
Command Not Valid
Invalid aid Code
Invalid ctag
Invalid Target Identifier
Extra Parameter
Parameter Missing
Parameter Not Valid
Data Not Ready
12713020-002-2 Revision D – April 2004