Symmetricom SSU-2000 User Manual page 303

Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-STATUS-OUTPUT:[tid]:
[aid]:ctag;
RTRV-USER:[tid]::ctag;
12713020-002-2 Revision D – April 2004
Valid aid code: ,
ALL SxAy[-z]
This command returns the condition (current operating mode
and status) of an output module or port.
The format of each port response line is:
^^^"aid:mstat,red,clksrc,pql,pstate" <cr lf>
where:
The first line contains the port aid.
= module status [OK|DIS|FLT]: where OK indicates
mstat
normal operation, and DIS or FLT indicate all outputs are
turned off
= redundant [NA|SxAy]: where NA = non-redundant,
red
and the aid = the redundant module identifier
= clock which is generating the output:
clksrc
[CLK-A|CLK-B|CLK-C|CLK-D]
= possible Priority Quality Level (SSM) being generated
pql
= port status [1|0|F], where 1 = enabled, 0 =
pstate
disabled, and F= faulted
Multiple message lines are returned if aid specifies one or
more output modules as follows:
^^^"aid:mstat,red,clksrc,pql" <cr lf>
^^^"aid:p1,p2,p3,...p20" <cr lf>
where:
The first line contains the module aid.
= module status is [OK|DIS|FLT], where OK = normal
mstat
operation, and DIS or FLT = all outputs are turned off
= [NA|SxAy], where: NA = non-redundant, and SxAy
red
= redundant module aid
= clock generating the output: [CLK-A |CLK-B
clksrc
|CLK-C |CLK-D]
= Priority Quality Level (SSM) being generated
pql
The second line contains:
= module identifier
aid
= port status: [1|0|F], where 1 = enabled, 2 =
pstate
disabled, F = faulted for all 20 outputs
Valid aid code: None
This command returns the current user list. The format of the
response message is:
^^^"username,level" <cr lf>
where:
= assigned user
username
= access level assigned to that user.
level
No password information is displayed. This command is only
accessible by Level 4 users.
TL1 Command Interface
Description
SSU-2000 User's Guide 303