Output Module Event Messages - Symmetricom SSU-2000 User Manual

Table A-9. LRM Event Messages (Continued)
Event Message
LBO, Port[2-3], 266 ft, COML
SlipCount, Port[2-3], 4, COML
BpvErr, Port[2-3], Clr, COML
RefFlt, Port[2-3], Off, COML
Circuit ID, Set
Err Delay, (0), 10 sec, COML
Alm Level, (1), Min, COML
Setup, Factory, COML
Table A-10. Output Module Event Messages
Event Message
Install, Output Module\
Remove, Output Module\
Enable, Output Module, COML\
Disable, Output Module, COML\
Restart, in 5 seconds, COML\
Cannot Enable, Output Module, COML\
Frame Mode, ESF, COML\
ZS, On, COML\
DS1 LEN, [0-5], len=133 ft., COML\
CRC, On, COML\
SSM Bit, 8, COML\
Min Clk Level, ACQ, COML\
Bypass, On, COML\
DutyCycle, Port= [0-1], 50/50, COML\
Delay, Port= [0-3], 4000ft, COML\
12713020-002-2 Revision D – April 2004
Event #
194 Line build out on ports 2 and 3 set to 266 ft.
196 Slip count on ports 2 and 3 set to 4
197 Clear BPV accumulated error count
198 Reference Fault Strategy for CTA Action
disabled
199 Port Circuit ID set
251 An alarm delay time change
252 An alarm level change
254 User defaults have been set and saved
Event #
129 Module Installation
130 Module Removal
131 Output module has been enabled
132 Output module has been disabled
133 Module re-boot
144 Output module cannot be enabled
193 Output framing type change
194 User changed output framing type
195 User changed output line length (DS1 only)
199 User has changed output framing type
201 User has changed output SSM bit position
(E1 only)
202 User has changed Minimum Clock Level to
turn on outputs
203 User has changed Bypass mode of
operation
204 CC signal duty cycle settings have been
changed for the port shown
205 CC signal phase offset settings have been
changed for the port shown
Event Messages
Event Description
Event Description
SSU-2000 User's Guide 261