Table of Contents
Advertisement
Interactive Command Set
GPS STATUS
Loc#
Sta PhaseA
------- --- -------- -------- --- ---
1A03-01 Ok
-143
1A05-01 Ok
-149
Level 2
Level 3
Allows you to change the setting of a specified Input module.
344 SSU-2000 User's Guide
PhaseB
Pql UTC
-145
2
Yes
-149
2
Yes
Same as Level 1 operation
Same as Level 2 operation, with the following additions:
INPUT xAy[-z] {ESF|D4|CCS|CAS|1MHZ|1.544MHZ|2.048MHZ|
5MHZ|10MHZ}
INPUT xAy[-z] {ZS|SSM|CRC}{ON|OFF}
INPUT xAy[-z] PRIORITY {0-10}
INPUT xAy[-z] {ENABLE|DISABLE}
INPUT xAy[-z] SSM {4|5|6|7|8}
INPUT xAy[-z] PQL {1-16}
INPUT xAy[-z] MTIE [{EL1|EL2|CL1|CL2}]{T10|T100|T1K|
T10K|T100K} value
INPUT xAy[-z] MTIE {PRS|DS1|G.811|G.823}
INPUT xAy[-1] GAIN {ON|OFF}
INPUT xAy[-z] CSFLT {HIGH|LOW|OFF}
INPUT xAy[-z] {LOS| AIS|OOF|BPV|CRC}{SET|CLR} value
INPUT xAy[-z] FREQ {A|B}{SET|CLR|TAU} value
Options are:
Sets the T1 framing mode: ESF or D4.
ESF|D4
Sets the E1 framing mode: CCS or CAS.
CCS|CAS
1MHZ|1.544MHZ|2.048MHZ|5MHZ|10MHZ
Sets the Input module clock frequency when input is not
running in framing mode. Only the clock frequencies
shown are valid. If the module is a framed T1 signal, the
CLK rate is 1.544MHz; if it is a framed E1 signal, the
CLK rate is 2.048MHz automatically.
Enables or disables Zero Suppression
ZS {ON|OFF}
For DS1: On = B8ZS, Off = AMI
For E1: On = HDB3, Off = AMI
Enables or disables Sync Status Message reading
SSM {ON|OFF}
Enables or disables CRC checking
CRC {ON|OFF}
Sets Input priority level, where: 0 = monitor,
PRIORITY {0-10}
1 = highest priority, and 10 = lowest priority
Enables the specified input port
ENABLE
Disables the specified input port. This clears all alarms
DISABLE
associated with an input and disables setting of further
alarms or use of the input measurements.
12713020-002-2 Revision D – April 2004
Advertisement
Table of Contents
Troubleshooting
