Table of Contents
Advertisement
Event Messages
Table A-8. Input Module Event Messages (Continued)
Event Message
Port, Dis, COML\
SSM, Auto, COML\
Priority, 5, COML\
SSM Bit, 4, COML\
Prov PQL, 5, COML\
MTIE, T100, L1, 550, COML\
Gain, On, COML\
CSFlt, Off, COML\
Err Cnt, BPV, 16, COML\
Clr Cnt, OOF, 5, COML\
Freq Err Limit, Clk-A, 100
Freq Clr Limit, Clk-A, 800
MTIE Clr Limit, T100, L1, 500, COML\
MTIE Limit, DS1, COML, Setting
PBO, Report, COML\
(Disable|Event|Report|None)
Freq Tau, Clk-A, 400, COML\
Err Delay, (0), 10 sec, COML\
Alm Level, (2), Maj, COML\
Elevate Time, 86400 sec, COML\
Setup, Save, COML\
Install, GPS/CDMA Module\
Remove, GPS/CDMA Module\
Enable, GPS/CDMA Module\
Disable, GPS/CDMA Module\
258 SSU-2000 User's Guide
Event #
199
User Enabled | Disabled input port
200
User changed SSM setup
201
User changed input priority level
202
User changed SSM Bit location (E1 only)
203
User changed input provisioned PQL
204
User changed input MTIE limits (L1 | L2)
205
User changed the input gain control
206
User changed input Cesium Fault control
207
Signal Alarm Error Count (LOS, AIS, OOF,
BPV, or CRC)
208
Current Signal Alarm Clear Count (LOS,
AIS, OOF, BPV, or CRC)
209
The frequency error limit settings have been
changed
210
The frequency clear limit settings have been
changed
211
The MTIE error limit settings have been
changed
212
The MTIE clear limit settings have been
changed
213
Phase Build-out system response has been
changed to the indicated setting
214
The frequency TAU limits have been set
251
An alarm delay time change
252
An alarm level change
253
An alarm elevation time change
254
User defaults have been set and saved
GPS Input Module Events
129
Module Installation
130
Module Removal
131
The input module has been enabled
132
The input module has been disabled
Event Description
12713020-002-2 Revision D – April 2004
Advertisement
Table of Contents
Troubleshooting
