Symmetricom SSU-2000 User Manual page 289

Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-NETYPE:[tid]::ctag;
RTRV-PING:::ctag::ip;
RTRV-PRMTR-AIS:tid:[aid]:ctag;
RTRV-PRMTR-BPV:tid:[aid]:ctag;
RTRV-PRMTR-CRC:tid:[aid]:ctag;
RTRV-PRMTR-LOS:tid:[aid]:ctag;
RTRV-PRMTR-OOF:tid:[aid]:ctag;
RTRV-PRMTR-ALARM:[tid]:[aid]:
ctag;
12713020-002-2 Revision D – April 2004
Valid aid code: none.
This command serves the same purpose as RTRV-HDR with
an element type message added. The response message
for is:
^^^"SSU2000" <cr lf>
Valid aid code: none.
This command allows for a remote host to be pinged via
TCP/IP. The ip parameter shall be given in the
###.###.###.### format, where ### is a number between 0
and 255. The response message for retrieve ping is
COMPLD if the ping was successful or DENY (SDNR) if
unsuccessful.
Valid AID codes:
SxAy[-z]
This command returns the erred and cleared second
thresholds for the signal faults.
The format for each response message line is:
^^^"aid:prmtr,errcnt,clcnt"<cr lf>
where:
= signal fault LOS, AIS, OOF, BPV, or CRC;
prmtr
= setting for the error threshold;
errcnt
= setting for the clear threshold.
clcnt
Valid AID codes:
SxAy[-z]
This command returns the alarm settings for the specified
module, or ALL alarms if no aid is specified.
The format for each response message line is:
^^^"aid:almnum,level,startdelay,cleardelay"<cr lf>
where:
= module or input port
aid
= alarm number
almnum
= Ignore, Report, Minor, Major, or Critical:
level
[IGN|RPT|MIN|MAJ|CRT]
= delay time or errored seconds count for
startdelay
start of the alarm
= cleared seconds count for clearing of the
cleardelay
alarm. Delay numbers are reported only if they are
settable for the alarm; otherwise they are reported as
IMMED (immediate).
TL1 Command Interface
Description
SSU-2000 User's Guide 289