Symmetricom SSU-2000 User Manual page 288

TL1 Command Interface
Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-INPUT-REF:[tid]::ctag;
RTRV-INV:[tid]::ctag;
or
RTRV-INVENTORY:[tid]::ctag;
RTRV-NAME:[tid]:[aid]:ctag;
288 SSU-2000 User's Guide
Valid aid code: None
This command returns the current input reference, reference
switch mode, and reference selection mode.
The format of the response message is:
^^^"port,swtmode,selmode"<cr lf>
where:
= auto return (revertive) selection, auto switch
swtmode
(but not revertive), or no auto switching [AR|AS|OFF]
= reference selection: [PRI|PQL] for priority
selmode
quality level or status message selection of inputs.
If the input port is not a valid reference the DENY response
is returned.
Valid aid code: None
This command returns the inventory management
information for the addressed module(s). The response will
be the complied message followed by the response
message(s). A summary for each module and shelf are
returned in the following format:
^^^"aid:desc,hw_part,hw_rev,hw_serial,sw_part,
sw_rev" <cr lf>
where:
is the text name of the module
desc
is the hardware part number
hw_part
is the hardware revision level
hw_rev
is the hardware serial number
hw_serial
field is the software part number (i.e.
sw_part
141xxxxx-xxx-x)
field is the software revision level
sw_rev
The aid reported is the shelf address.
The desc and hw_part are per the following table:
aid desc
S2-S5 SSU-2000 SSU-2000 (M3) 25413140-000-0
S2-S5 SSU-2000 SSU-2000 (M3) 25413141-000-0
Valid AID codes:
S1A2
This command returns the name assigned to Input or Output
ports. One name of up to 20 characters is returned for each
port designated by the aid. The format for each response
message line is:
^^^"aid:"name"" <cr lf>
When the aid is S1A2, the name is that of the unit.
When the aid is an I/O module or port, the name is the
assigned port name.
Description
hw_part
25413140-001-0
25413141-001-0
or any I/O module or port.
12713020-002-2 Revision D – April 2004