Adding A Manager Ip Address; User And Manager Tables - Symmetricom SSU-2000 User Manual

At the prompt, type 3 and press ENTER.
Note: Valid authentication key and privacy key characters include
numbers, upper and lowercase letters, and the character set
":;<=>?@". The semicolon functions properly only in ICS mode,
and the colon must be enclosed in quotes in TL1 mode, as
"
enclose the input in quotes, as "
not use spaces in usernames.

Adding a Manager IP Address

You can add up to four managers in the SNMP manager table.
TL1 Command
To use the TL1 command to add an SNMP manager IP address for traps with
username XYZ, type:
SET-PRMTR-SNMPV3-MANAGER:::::ADD,192.100.100.100,XYZ;
ICS Command
To use the ICS command to add an SNMP manager IP address and username,
type:
SNMP MANAGER ADD 192.100.100.100 XYZ

User and Manager Tables

ICS and TL1 commands allow users to:
Add up to five SNMP user names in the SNMP user table
Delete/display SNMP user names (read community string) and their associated
access levels
TL1:
SET-PRMTR-SNMP-USER: [tid]::ctag::mode,[rd_community],
[wr_community],[level];
and
RTRV-PRMTR-SNMP-USER:[tid]::ctag;
ICS:
SNMP [USER|MANAGER]
The factory default setting for read community string is "public"
The factory default setting for write community string is "private"
Disable/enable SNMP
TL1:
SET- PRMTR -SNMP-MODE:[tid]::ctag::[mode], [trap_filter];
and
RTRV-PRMTR-SNMP-MODE:[tid]::ctag;
12713020-002-2 Revision D – April 2004
" "
USER:NAME or PASS:WORD
". To enter lowercase letters,
" "
UserName or PassWord
then press ENTER.
SNMP Protocol
". Do
SSU-2000 User's Guide 387