Symmetricom SSU-2000 User Manual page 343

INPUT
Use this command to access to the input status, hardware configuration, and alarm
settings.
Level 0
Level 1
Example:
SSU_2000+>input
2001-07-16T12:57:14Z ID: SSU2000 Name: SSU_2000
INPUT STATUS
O I O P R -MTIE1-
Loc# Sta PhaseA
------- --- -------- -------- --- --------- ---- ---- ---- ---- --- ---
1A04-01 Dis NA
1A04-02 Dis NA
1A04-03 Dis NA
1A06-01 Sel -1
1A06-02 Dis NA
1A06-03 Dis NA
1A08-01 Dis NA
12713020-002-2 Revision D – April 2004
Not applicable
INPUT [xAy[-z]][STATUS|SETUP]
If you do not provide a parameter, the command displays all the
input module status information in the unit. If a specified input
address is provided, that input status and setup information
appears.
Options are:
Use this command to display input status information.
STATUS
Use this command to display input setup information.
SETUP
Status information: status, phase A/B values, PQL, hardware alarm
(LOS, AIS, OOF, BPV, CRC) statuses, MTIE status.
Setup information: port (Enable or Disable), framed signal (D4 or
ESF if DS1, CAS or CCS if E1), unframed signal (if specified as
CLK), zero suppression (ON or OFF), CRC (ON or OFF), SSM (ON
or OFF), PQL provision value (1-16), priority (0-10), high gain (ON
or OFF), cesium fault indication level (High, Low, OFF), MTIE mask
limits, hardware alarm (LOS, AIS, OOF, BPV, CRC) error count and
clear error count setting.
If E1: SSM bit position (4 through 8)
The alarm level and delay time are handled by the ALARM
command. The alarm elevation time is handled by the ELEVTIME
command.
L A O B C
-MTIE2- FREQ
PhaseB Pql S S F V C
NA 4 / / / /
NA 4 / / / /
NA 4 / / / /
-2 4 / / / /
NA 4 / / / /
NA 4 / / / /
NA 4 / / / /
A B A B
Ok Ok Ok Ok
Ok Ok Ok Ok
Ok Ok Ok Ok
Ok Ok Ok Ok
Ok Ok Ok Ok
Ok Ok Ok Ok
Ok Ok Ok Ok
Interactive Command Set
A B
Ok Ok
Ok Ok
Ok Ok
Ok Ok
Ok Ok
Ok Ok
Ok Ok
SSU-2000 User's Guide 343