Symmetricom SSU-2000 User Manual page 302

Synchronization supply unit and the synchronization distribution unit
Hide thumbs Also See for SSU-2000:
Table of Contents

Advertisement

TL1 Command Interface
Table B-5. TL1 Retrieve Commands (Continued)
Command
RTRV-STATUS-LRM:[tid]:[aid]:
ctag;
RTRV-STATUS-NTP:[tid]::ctag;
302 SSU-2000 User's Guide
Valid aid code:
,
ALL
SxA[y[-z]]
This command returns the condition (current operating mode
and status) of an LRM module or port. The format of
response messages are:
^^^"aid:mstat,clksrc,ctaid" <cr lf>
^^^"aid:pstat,frame,los,ais,lof,bpv,slip,
slipcount,los_side2" <cr lf>
Line 1 contains:
= module or port
aid
= {ENA|DIS} where ENA indicates the module is
mstat
enabled, and DIS indicates the module is disabled
indicates which clock {A|B|C|D|NONE} is the
clksrc
reference
indicates if the CTA is installed or not
ctaid
{NONE|DUAL|QUAD} where NONE indicates there is no
CTA installed, DUAL indicates Dual (2 Port) CTA
installed, and QUAD indicates Quad (4 Port) CTA
installed.
Line 2 contains:
= module or port
aid
= {OK|CUT|DIS} for port status where OK
pstat
indicates this port is enabled and functioning correctly,
CUT indicates that this port is in cut-through mode, and
DIS indicates that this port is disabled and not in
cut-through mode.
= {D4|ESF|NONE}
frame
,
,
,
, and
los
ais
lof
bpv
condition {F|OK} where F indicates an error has occurred
indicates the slips in a 24 hours period
slipcount
(the LOS of Side 2) is {F|OK} where F
los_side2
indicates an error occurred.
Valid aid code: None
This command returns the current network timing protocol
status for the unit. The format of the response message is:
^^^ip1,offset,delay,dispersion"<cr lf>
^^^ip2,offset,delay,dispersion"<cr lf>
^^^ip3,offset,delay,dispersion"<cr lf>
where:
= the server IP address used by the client or
ip
broadcast client or broadcast server
= the number of seconds (partial seconds) that
offset
the local time was adjusted by
= the calculated delay in the communication path
delay
= a value that indicates the accuracy of the
dispersion
offset/delay settings. There can up to three NTP IP
addresses listed
Description
are the current second error
slip
12713020-002-2 Revision D – April 2004

Advertisement

Table of Contents
loading

Related Products for Symmetricom SSU-2000

This manual is also suitable for:

Sdu-2000

Table of Contents