Installing The Image Memory Simm (Option) - Kyocera KM-4230 Service Manual

3-1-4 Installing the image memory SIMM (option)

Installation of add-on image memory to the memory copy PCB requires the following
part:
Image memory (16 MB or 32 MB 72-pin SIMM)
<Procedure>
1. Detach the SRDF connector.
2. Remove the seven screws holding the rear cover and then the cover.
3. Remove the eight screws holding the main PCB cover and then the cover.
• To install an add-on image memory to memory copy PCB 2 only, proceed to step
5.
Screws
Main PCB cover
Screws
M4
Screws
Figure 3-1-41
Memory copy PCB 2
Memory copy PCB 1
2A3/4
3-1-33