Kyocera KM-4230 Service Manual page 367

2A3/4
7. Wind one end of the new wire at lease five turns around the end of the charger
spring.
8. Hook the other end of the charger spring onto the catch on the transfer charger
terminal on the rear of the transfer charger housing.
9. Pass the charger wire through the notches in the front and rear of the transfer
charger housing, and stretch it.
10. Insert the charger wire under the charger wire retainer pin into the hole at the front
of the transfer charger housing.
∗ The charger wire must be adjusted so that the charger spring stretches to
12.5 ± 1.5 mm.
∗ Cut off the excess wire under the charger wire retainer pin.
11. Refit all removed parts.
∗ When installing the main charger assembly, fix the assembly pushed all the way
toward the machine front.
Charger spring
±
12.5 1.5 mm
Not more than 2mm
Not more than 1mm
Transfer
charger terminal
3-3-58
Transfer charger terminal
Rear of the transfer
charger housing
Figure 3-3-68 Installing the charger wire
Charger wire
Front of the transfer
charger housing
Charger wire
retainer pin
Not more than 2mm