Kyocera KM-4230 Service Manual page 212

• Operation execution
The specified operations and auto adjustments are performed by pressing the print key. In
a maintenance item where multiple operations can be performed, the item to be executed
is selected by pressing on it on the touch panel.
Drive motors and fans ON
1
1 Items ··································· Displays the selected item in reverse.
2 Print key ······························ Starts operation.
3 Stop/clear key ····················· Stops operation.
• Interrupt copy mode
Outputting a test copy or VTC pattern is required in some maintenance items. Such an
output is enabled by pressing the interrupt key to enter interrupt copy mode.
However, since this function is restricted depending on maintenance items, only outputting
may be enabled, or a test copy even from an original may not be as good as that made in
normal copy mode.
To return the screen from interrupt copy mode to maintenance mode, press the interrupt key
again.
MAIN MOTOR
CONV MOTOR
FEED MOTOR
U030
Figure 3-2-2
/ C
Metric
3 2
Inch
Stop/
Clear
Start
3 2
2A3/4
3-2-3