Kyocera KM-4230 Service Manual page 401

2A3/4
6. Remove the two screws holding the DF original feed lower guide and the two
screws holding the DF original feed upper guide.
7. Loosen the other two screws on the DF original feed lower guide.
8. While lifting the DF original feed upper guide and pressing the original set switch
actuator, remove the DF original feed lower guide.
Screws
(To be loosened only)
Original set switch
9. Detach the original set switch 3-pin connector.
10. Remove the two screws holding the separation pulley retainer.
3-3-92
Screw
actuator
Figure 3-3-109
Figure 3-3-110
DF original feed upper guide
Screw
Separation pulley retainer
3-pin connectors
DF original
feed lower
guide
Screws