Kyocera KM-4230 Service Manual page 355

2A3/4
3. Remove the two screws holding the main charger assembly and then the assembly.
Figure 3-3-53 Detaching the main charger assembly
4. Loosen the cleaning blade pin. Move the cleaning blade lever in the direction of the
arrow so that the cleaning blade is kept away from the drum and then tighten the
cleaning blade pin.
5. Remove the two screws and open the upper cleaning cover on the left of the drum.
6. Remove the two screws and open the image formation rail in the direction of the
arrow.
Screw
3-3-46
Cleaning blade lever
Screw
Image formation rail
Figure 3-3-54
Screws
Main charger assembly
Upper cleaning cover
Screw
Cleaning blade pin
Screw