Kyocera KM-4230 Service Manual page 345

2A3/4
( 7 ) Adjusting magnification of the scanner in the main scanning direction
Perform the following adjustment if the magnification in the main scanning direction is
not correct.
U 066
U065
(P.3-3-39)
Caution: Check the copy image after the adjustment. If the image is still incorrect,
perform the above adjustments in maintenance mode.
<Procedure>
Start
Enter maintenance mode.
Enter "065" using the numeric keys.
Press the print key.
Select "MAIN SCAN ADJ"
(main scanning direction).
Press the interrupt key.
Set an A3 size original and
make a test copy with
the 100% magnification.
Is the image correct?
Yes
Press the stop/clear key.
Exit maintenance mode.
End
3-3-36
U403
(P.3-3-40)
Press the print key.
For copy example 1, increase the
value using the Up key.
No
For copy example 2, decrease
the value using the Down key.
Setting range: –25 - +25
Reference: 0
Changing the value by 1 changes
the magnification by 0.1%.
Increasing the value makes
the image wider, and decreasing it
makes the image narrower.
Original Copy
example
Figure 3-3-44
The new setting
is stored.
Copy
example 2