Kyocera KM-4230 Service Manual page 204

2A3/4
3-1-8 Installing the dehumidifier heaters (service part)
Dehumidifier heater installation requires the following parts:
Two dehumidifier heaters (P/N 33960020): for 220 - 240 V specifications
Two dehumidifier heaters (P/N 34860030): for 120 V specifications
Two heater bases (P/N 54107410)
Eight BVM4 x 06 bronze binding screws (P/N B1304060)
Eight EDS-2 edgings (P/N M2104210)
Relay wire (P/N 53310390)
Six SG-110 V0 bands (P/N M2107200)
<Procedure>
1. Fit the dehumidifier heaters to the heater bases using two screws for each.
Screws
2. Remove the two screws from each of the deck right cover, deck left cover and deck
rear cover and then the covers.
3. Open the large paper deck.
4. Detach the deck paper conveying motor connector.
5. Remove the spring from the deck paper conveying motor bracket.
6. Remove the four screws holding the deck paper conveying motor bracket and then
the bracket.
7. Remove the two screws holding the deck paper conveying unit assembly and then
the assembly.
3-1-44
Heater base
Dehumidifier heater
Left
Figure 3-1-53
Connector
Deck paper conveying
unit assembly
Figure 3-1-54
Screws
Dehumidifier heater
Right
Heater base
Spring
Screws
Deck paper conveying
motor bracket
Screws