( 5 ) Adjusting the position of the rack adjuster
Perform the following adjustment if there is a regular error between the centers of the
original and the copy image on paper fed from the drawer.
<Procedure>
Start
Make a test copy at 100%.
Is the center of
the image aligned with that
of the original?
Figure 3-3-23 Adjusting the position of the rack adjuster
Yes
End
Screws
Original
Loosen the three screws holding the
rack adjuster and change the position
of the adjuster so that the centers of
No
the original and the copy image are
aligned.
• For example 1, move it toward the
machine front (
• For example 2, move it toward the
machine rear (
Rack adjuster
Copy
example 1
example 2
Figure 3-3-22
).
).
2A3/4
Copy
3-3-17